Configuring the Face detection module🔗

To use the module, enable and configure it.

Launch the Eocortex Configurator, go to the /config/svg/ico-tab-cams.png Cameras tab, select a camera in the list located on the left side of the page, and set up the motion detector on the Motion detector tab on the right side of the page.

Then switch to the Analytics tab and enable the module using the /svg/ico-switch-on.png toggle.

../../_images/module-turn8.png

Clicking the /config/svg/ico-settings.png button opens the module setup window.

../../_images/configure2.png

In the settings window it is required to set the module efficiency. This parameter influences the computer system resources: processor load and RAM usage. High efficiency of the module operation consumes more system resources that the medium efficiency.

Warning

The module will start working only when the settings are applied.