Configuring the FishEye Dewarping module🔗

To use the module, enable and set it up.

To do that, launch the Eocortex Configurator application, go to the /config/svg/ico-tab-cams.png Cameras tab, select a camera in the list located on the left side of the page, go to the Analytics tab and enable the module using the /svg/ico-switch-on.png switch.

../../_images/module-turn18.png

Clicking the /config/svg/ico-settings.png button opens the module setup window.

../../_images/fisheye-configure.png

In the settings it is required to set the image radius by dragging the image boundary: the circle must coincide with the camera image boundary. If needed, it is also possible to drag the center of the circle using the mouse.

Warning

The module will start working only when the settings are applied.