Module setup

To use the module, enable and set up the software motion detector, then activate the module itself.

Launch the Eocortex Configurator, go to the Cameras tab, select a camera in the list located on the left side of the page, and set up the motion detector on the Motion detector tab on the right side of the page.

Then switch to the Analytics tab and enable the module using the toggle.

Clicking the button opens the module setup window.

In the opened settings window, select the needed detection options: Smoke, Fire.

Two operating modes are available for fire detection: Based on motion detector and Based on neural networks.

Note

Based on neural networks operating mode ensures more accurate fire detection.

Warning

For the Based on neural networks operating mode, it is required to install the Eocortex Neural Networks software package; a video card with the parameters matching the module’s requirements is also necessary.

Warning

The module will start working only when the settings are applied.